PERHITUNGAN PELAT DATAR BETON BERTULANG DENGAN METODE PERENCANAAN LANGSUNG DAN METODE PORTAL EKIVALEN PADA PROYEK PEMBANGUNAN GEDUNG DISPERINDAG KOTA SAMARINDA

Abstract

Flat plate is a plate system with the principle of replacing the function of the beam along the lines of columns with the floor plate, while the edge of the beam should stay there or not.

The aim of this project is to determine the results of the calculation of the flat plate system with the direct method and equivalent methods portal at the same equivalence ratio of moment magnitude and deviation.

In this calculation, Flat Plates planned by using the direct method and the method of planning portal equivalent. Planning methods should be a minimum direct discharge of duties continuous spans in each direction, the panel must be rectangular with a ratio between the length of the span short span measured between the axis to the axis of the pedestal is not more than two. Method equivalent portal is an approach of the real order that is the framework of a three-dimensional portal into the framework of a two-dimensional portal in the field of the column. This approach requires the existence of a relationship between the columns with column plate is transfer the bending strength of the plate to end the meeting with the column component.

The results of this planning is Flat Plates: plates or thick plate dimensions (15 cm); to use the flexural reinforcement diameter f 12; shear reinforcement using ordinary reinforcement using reinforcement diameter f 12 of 4 pieces per side; whereas shear reinforcement steel profiles using WF steel. 100.100. In planning this Flat Plates, obtained the advantage that in terms of artistic look better, and easy to set up as required at the completion of the end.